Introduction
Pressure washing in Nashville is an affordable and effective way to clean and restore the appearance of your fence. Pressure washers can be purchased at just about any home improvement store, but they don’t have to be expensive. Pressure washing isn’t just for wood fences either; you can use it on brick walls or other surfaces too! In this Pressure Washing Nashville article, we’ll show you how easy pressure washing is as well as some common mistakes that people make when doing it themselves.
Pressure washing your fence can keep it looking great year round.
Pressure washing your fence is a great way to keep it looking like new. Fences are exposed to the elements, so they can easily become dirty and worn over time. Pressure washing quickly removes dirt and other buildup from the surface of your fence, restoring its original appearance.
Pressure washing is an affordable, effective way to clean and restore the appearance of your fence.
- Pressure washing is an affordable, effective way to clean and restore the appearance of your fence. The cost of pressure washing your fence depends on the size of your property and the Pressure Washing Nashville materials used in its construction. A typical residential pressure washing job runs between $150 and $200, but can be higher or lower depending on factors like:
- How much square footage will be covered?
- What type of equipment do you need to rent or buy?
- How much time it takes for someone who isn’t experienced in using this kind of tool (if you decide not hire a professional).
- Once you’ve decided what works best for your needs, there are several ways to go about getting it done right.
Even a small pressure washer can get great results when cleaning your fence.
- What is a pressure washer?
A pressure washer is a machine that uses water and high-pressure to clean surfaces. The cleaning power of a pressure washer depends on the amount of gallons per minute, also known as GPM, that it pushes through its hose. For example, a 1.5 GPM engine has enough power to clean fences but not driveways or sidewalks.
- How many gallons per minute (GPM) should I buy?
The answer depends on what you want to use Pressure Washing Nashville for: if you’re looking to clean your fence, then something between 1 and 2 GPM will work great; if you need something more powerful than that, then get something around 2-4 GPM range instead!
Some common mistakes to avoid when pressure washing your fence.
- Don’t hold the pressure washer too close to the fence. You’ll end up destroying your fence.
- Don’t move the wand too quickly across a Pressure Washing Nashville board—you’ll want to move slowly in order to get rid of mold and mildew without damaging the wood or splintering it.
- Don’t use too much pressure on your machine’s spray—if you’re using too much pressure, you could cause damage to your fence by pushing water into gaps between boards. On top of that, strong streams of water can sometimes lift up sections of paint so they start peeling off (not good!).
Freshly stained wood fences are more susceptible to damage than fences that have been treated for at least a few days.
Newer fences that have been stained or painted are more susceptible to damage than older fences. While pressure washing a fence may be necessary, it is best to wait a few days before doing so. If you must wash your new fence, use the lowest pressure setting possible and clean only one section of the fence at a time.
Before you start pressure washing, you’ll need to remove any dirt that’s stuck in between the wooden slats or pickets on your fence.
Before you start pressure washing, you’ll need to remove any dirt that’s stuck in between the wooden slats or pickets on your fence. Use a wire brush with medium Pressure Washing Nashville bristles to remove dirt and debris. If it’s stubborn dirt that won’t come off, use a chemical cleaner like TSP (trisodium phosphate) mixed with water. This is often referred to as “whitewash” and will help loosen up any debris stuck in the cracks of the board.
It’s important to do this step before the wood dries out or else it will be harder for you later on when it comes time for sanding down that area!
The best time to pressure wash your fence is on a clear day with no rain in the forecast for at least 24 hours afterward. This will give the wood plenty of time to dry before any precipitation falls again.
Pressure washing your fence is a great way to clean up and make sure your neighbors don’t judge you for having a dirty, ugly fence. However, it can also be very damaging if done improperly. The most important thing to remember when pressure washing wood fences is that they should not be pressure washed while they are wet; they need time to dry after being cleaned.
The best time to pressure wash your fence is on a clear day with no rain in the forecast for at least 24 hours afterward. This will give the wood plenty of time to dry before any precipitation falls again.
If you have an older or more delicate wooden fence, it may be best for you not to pressure wash at all because this could easily damage the finish on your fence or even remove its stain entirely!
If you notice any rows of rotting wood slats, fill it in with some wood filler so that water doesn’t enter this area in the future and cause further deterioration.
Wood filler is a type of putty that is used to fill holes, cracks and other defects in wood. The first step to using it is to ensure that the area is clean and dry. Next, apply the wood filler with a putty knife or similar tool, spreading it out until it’s even across the surface. Allow this to dry completely before sanding away any excess with a fine grit sandpaper (120-150). Once you’ve done this, clean off all dust from the surface of your project with warm water and soap or detergent before applying primer or paint as needed.
Pressure washing can make your fence look like new again
Pressure washing in Nashville is an affordable way for you to clean and restore your fence. It can be done by hand or with a power washer, so it doesn’t matter if your fence is made from wood, vinyl, or composite materials. The process can be used on new fences as well as old ones. If you are nervous about damaging your fence, it might be best to contact Wash Nash TN for your pressure washing needs. Hiring a professional will alleviate the stress and worry about damaging your fence.
For more information about Pressure Washing Nashville contact us today!
Conclusion
If you want your fence cleaned, there’s no better way than by using a pressure washer. Pressure washing is quick and easy, and it doesn’t take long at all before you’ll see results! If you’re looking for a great way to restore the appearance of your fence or deck, then this is definitely something worth considering.